All ideas

Currently, iModel performs clearance checks using a single, uniform value across all directions. This proposed enhancement introduces the capability to define clearance values specific to each direction—such as separate horizontal and vertical cle...

It would be nice to kind of have the same selection set / dialog box as we have in Microstation / ORx, as it gives much more options when wanting to create a selection set. It would also be nice with a level manager, so manipulating the levels / c...

I’d like to suggest making the Saved Views settings more accessible by allowing them to be docked as a panel. This would enable quick toggling of specific settings—such as turning the camera only/filter content —without needing to go into the full...

Our Urban Planners miss a simple shadow slider. It would be nice if there would be a simple popup with a wider slider. Now the shadow Slider is hidden in the presentation bar. We also miss the capability to set Daylight Savings Time.

We can schedule the regular synchronizations from ProjectWise, but if we are building a composite model we still have to manually run the transform. Adding a schedule would be useful if we were creating discipline specific iModels but also wanted ...

More optimized IFC exports which use type instancing and other optimizations would greatly reduce file size and increase usability of the IFCs exported out of the i-twin engine.

Please allow civil tools when doing clash detection. The measurements, like minimum clearance, and the ability to create cross sections at a clash i vital to identify and solve the clash properly. Right new it is required to either exit the clash ...

It would be useful to be able to add a admin custom warning which pops up on Design Review when opening an iModel. This could be a caveat or something useful you want the user to know. Perhaps limitations of the iModel for example.

It would be good to be able to rotate a section. Sometime the section doesn't quite line up with the orientation you want and to be able to rotate it rather than trying to redraw it perfectly. Also if you could make the section follow an alignment...

Currently, 3D elements located under the map layer cannot be selected unless the terrain is temporarily disable in the Bing map. Viewing the terrain (Bing map) with the ability to select elements below it will allow to interact with all elements i...