In a plant we have components but with them we have logical groups of those components which carry important information. E.g. a pipeline which knows what fluid is flowing through it etc. If we are able to see the hierarchy of components and there...
Guest
over 5 years ago
in Design review
0
Already exists
it would be very useful to have the option to view the model offline on a tablet so it can be accessed on site. I know revizto has this option so would it be possible to include in iTwin
Tab or Reset to cycle through closely located Linear Geometry
In many circumstances, Linear Geometry may be located in the same location or very close to each other and it gets very difficult to find desired geometry, especially to use the Civil Review tools. Adding a selection cycling key like tab or reset ...
Guest
about 4 years ago
in Design review
3
Already exists
When selecting the top view oreintation in the rotation cube the model should rotate so that top view is with north point up. It seems to go to the closest direction on top view when clicked now.
Guest
about 5 years ago
in Design review
1
Already exists
It would be useful for migrating existing design review processes to the imodelhub if the saved views that have already been set up in the source i.dgns could be imported to the Design Review App.
Guest
about 5 years ago
in Design review
0
Already exists
Please add status column for Tests tab in Design Validation service so when the test is running/has completed/has failed that information is visible - can be similar to imodel connection sync status.
Would be useful to navigate directly to iModel from Connection Configuration page
When data is successfully synchronized, and while I am in Connection Configuration page, would be good to open this iModel directly from this page instead of navigating to iModel Manager page > find this iModel and open it.
When suing Bentley software I map XButton 1 to 'rotate view drag' to be able to simply swirl the model around by holding down the mouse wheel - saves a lot of time than to go and select 'Rotate view' every time you need to view a new angle
Guest
about 5 years ago
in Design review
1
Already exists
3
Already exists
0
Already exists
