Skip to Main Content
iTwin Ideas Portal
Status Shipped
Categories Power BI
Created by Guest
Created on Jan 31, 2020

How can we surface iModel data to PowerBI

A data connector would be extremely helpful to surface data into our PowerBI Dashboards

This can be as simple as a ecSQL which returns data ... based upon a ProjectID and iModelID

  • Attach files
  • Guest
    Reply
    |
    May 20, 2020

    Hello!
    How are you?
    I see a page with the implementation of functionality and pictures, and when I go to the download page, it shows a blank page.

    ___________________________________________
    Best regards, Andrey Aksenov
    tel.: 8 (727) 228-25-65 ext.: 5032
    [cid:image004.jpg@01D62E80.9DEA5500]
    www.aaengineering.kz
    This email is for the use of the intended recipient(s) only. If you have received this email in error, please notify the sender immediately and then delete it. If you are not the intended recipient, you must not keep, use, disclose, copy or distribute this email without the author's prior permission. We have taken precautions to minimize the risk of transmitting software viruses, but we advise you to carry out your own virus checks on any attachment to this message. We cannot accept liability for any loss or damage caused by software viruses. The information contained in this communication may be confidential and may be subject to the attorney-client privilege. If you are the intended recipient and you do not wish to receive similar electronic messages from us in future then please respond to the sender to this effect.

  • Kaustubh Page
    Reply
    |
    May 19, 2020

    We have shipped beta version of Power BI Data Connector where you can run ECSQL queries against an iModel from Power BI Desktop

    It is available under iTwin Design Insights service.